cwsink
Automotive
- Mar 22, 2006
- 163
Hello,
I'm getting an error that won't let me use the hole wizard. It is an access error related to toolbox. Below is the error which I'll explain further. The computer name is my computer and I have been setting up the toolbox, but I'm not logged in as the Admin (I do have admin rights though). Earlier this morning, I was able to use the hole wizard without getting this error. I'm on SW 2007 sp1.1
Any suggestions for cause, and/or fixes?
Thank you,
Craig Sink
Mechanical Engineer
Force Design, Inc.
I'm getting an error that won't let me use the hole wizard. It is an access error related to toolbox. Below is the error which I'll explain further. The computer name is my computer and I have been setting up the toolbox, but I'm not logged in as the Admin (I do have admin rights though). Earlier this morning, I was able to use the hole wizard without getting this error. I'm on SW 2007 sp1.1
Any suggestions for cause, and/or fixes?

Thank you,
Craig Sink
Mechanical Engineer
Force Design, Inc.