Toolbox Rebuild Issue

[MikeInSoCalif]

For some strange reason, when I insert bolts from the toolbox into an assembly, they have the rebuild icon attached, and will not rebuild even with a cntrl-Q?

It just started happening the other day. Its not every config of the bolts however. For example, in a current assembly I have 1/2-13 X 1-3/4 bolts that have the rebuild issue, and right below it in the assembly are 1/2-13 X 6-1/4 that are just fine.

Any ideas?

Mike Puckett
Group Leader
Los Angeles/Orange County SW User Group
Need Usergroup Info?

http://www.swugn.org

 

[cwsink]

Which SP are you on? SP 4.0 caused this on our system; SW fixed the problem with 4.1



Craig Sink
Mechanical Engineer
Force Design, Inc.

 

[MikeInSoCalif]

We are on 4.0 It happened a few weeks after we went to 4.0, so I dont see an issue there.

Mike Puckett
Group Leader
Los Angeles/Orange County SW User Group
Need Usergroup Info?

http://www.swugn.org

 

[SBaugh]

That is known bug in SP4.0 you can either rollback to your previous SP or upgrade to SP4.1 were this issue is fixed at.

SPR# 315374 - Toolbox fasteners in assembly have constant rebuild icons on them when the the assembly is opened in SP4.0.

Regards,

Scott Baugh, CSWP

http://www.scottjbaugh.com

faq731-376