Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Tooling vs. grinding forces - How to predict?
- Thread starter MICKSDA
- Start date
grinderguy
Mechanical
- Thread starter
- #3
? Maximum unit horsepower: 30 hp / ( in 3 / min )
? Wheel speed, vw 8200 ft / min
? Width of cut, wc 1.250 in (actual surface:2.855 in )
? Feed rate, vt 3 in / min
? Depth of cut, Dc 0.056 in
? Wheel diameter 16 in
? Force exerted by the magnetic chuck 45 lbf / in2
? Wheel speed, vw 8200 ft / min
? Width of cut, wc 1.250 in (actual surface:2.855 in )
? Feed rate, vt 3 in / min
? Depth of cut, Dc 0.056 in
? Wheel diameter 16 in
? Force exerted by the magnetic chuck 45 lbf / in2
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question
- Locked
- Question