trim curve

[miked64]

NX8
i want to turn off the associtive switch under- trim curve- settings
so when i start a new session it stays off. i can toggle it off per session but would rather it stay off for good.

 

[JohnRBaker]

It stays OFF for me; I toggle it OFF in one session and then restart NX it's still OFF.

However, if you want it to never have it toggled ON in the first place, go to...

Customer Defaults -> Curves -> Curve Associativity -> All

...and toggled OFF the 'Trim Curve' option.

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA

http://www.siemens.com/plm

UG/NX Museum:

http://www.plmworld.org/p/cm/ld/fid=209

To an Engineer, the glass is twice as big as it needs to be.

 

[miked64]

I have done this and it still stays on?

 

[JohnRBaker]

As I said before, it stays OFF for me (running NX 8.0.2.2) even though I have NOT toggled it OFF in Customer Defaults. With that in mind, go to...

Customer Defaults -> Gateway -> User Interface -> General

...and check to make sure that the 'Save Dialog Box Settings between Sessions' option is toggled ON.

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA

http://www.siemens.com/plm

UG/NX Museum:

http://www.plmworld.org/p/cm/ld/fid=209

To an Engineer, the glass is twice as big as it needs to be.

 

[miked64]

The changes I made were not taking affect, I had to delete my
DialogMemory.dlx file. It makes a new one upon every exit of UG.
Upon doing that it started working, i believe it was hung up there.

Thanks