BeliMawr
Mechanical
- Apr 22, 2003
- 30
Hello,
Is it possible to update all the ipart at once?
Example:
The length of a vertical rod changes by 20mm, so the rest of the vertical rods derived from that rod by ipart should also lengthen by 20mm. Now I have to click every single ipart to update the length. Would be nice if you could do that automaticaly in inventor 2011.
Thanks in advance!
Beli
Is it possible to update all the ipart at once?
Example:
The length of a vertical rod changes by 20mm, so the rest of the vertical rods derived from that rod by ipart should also lengthen by 20mm. Now I have to click every single ipart to update the length. Would be nice if you could do that automaticaly in inventor 2011.
Thanks in advance!
Beli