V5 Memory Management Warning

[sleske]

Hey all.
The propblem I'm having is small, yet annoying. I'm trying to generate a CATPart from o product file. Now, the the entire Product file, with Catparts, is small. About 8 Catparts make up the Product file , at best 5MB total.
I can not generate A CatPart from this Prod file. I keep getting this "Warning: Memory limitations exceeded" window.
I was guessing that there was some setting in my tool options that is set pretty low, but I can not seem to find it.
Any suggestions?
Thanks, Sleske

 

[Azrael]

Check the setup in tools/options... the General branch and General tab, last post is about memory warning, what is the setup there??

 

[sleske]

Memory Warning
Box not checked.

 

[Azrael]

Sounds strange, think that message is triggered by that option. Have you cleared you catsettings?

 

[catiajim]

Are you having the same problem with other parts? Or is it just these? Try running a CATDUA against your parts in this case.