May 19, 2006 #1 Crazyfrog Aerospace Sep 21, 2005 10 0 0 GB Do anybody know a way to choose the default orientation of a view ? Because, in a rotated a view all the center lines/axis/2 component are coming in the former orientation. It could be usefull to get these in the sheet orientation.
Do anybody know a way to choose the default orientation of a view ? Because, in a rotated a view all the center lines/axis/2 component are coming in the former orientation. It could be usefull to get these in the sheet orientation.
May 19, 2006 #2 itsmyjob Mechanical Apr 11, 2002 2,375 0 0 CA Hi, I do not understand your question completly but have a look at view / named views. then select front view and properties. This will define a CATStandardViewSetting.CATSettings file. Eric N. indocti discant et ament meminisse periti Upvote 0 Downvote
Hi, I do not understand your question completly but have a look at view / named views. then select front view and properties. This will define a CATStandardViewSetting.CATSettings file. Eric N. indocti discant et ament meminisse periti
May 19, 2006 Thread starter #3 Crazyfrog Aerospace Sep 21, 2005 10 0 0 GB In fact, I've found the parameter to be modified : drafting/layout/auxiliary and section views orientation according to profile It is modifying the default orientation for the auxiliary views. Upvote 0 Downvote
In fact, I've found the parameter to be modified : drafting/layout/auxiliary and section views orientation according to profile It is modifying the default orientation for the auxiliary views.
May 19, 2006 #4 itsmyjob Mechanical Apr 11, 2002 2,375 0 0 CA ok i was talking about something else then. Eric N. indocti discant et ament meminisse periti Upvote 0 Downvote