weldment cut list decimals

[daanh]

Hi, I have the same question as in this thread:

http://www.eng-tips.com/viewthread.cfm?qid=204860

The solution stated there doesn't work for me. The weldment cut list stays at two decimals....

Thanks, Daan

 

[CorBlimeyLimey]

Works fine for me. Which version & SP of SW are you using?

 

[daanh]

Hi, I use the 2014-2015 student edition. I see the problem now: I was changing the precision in the dimensions section. I should change the units in the unit section. Very confusing.

Thanks! Daan

 

[daanh]

OK, this is strange. When I change the units decimals to none, the lenght gets updated, but the angle stays the same. Any thoughts on this?

 

[CorBlimeyLimey]

Change the units options when in the weldment mode, not the drawing mode.

 

[daanh]

What do you mean? Back in the part file?

Edit: that works, thanks.