whats up with lines that cant be trimmed or extended?

[uGlay]

when sketching sometimes ill run across a line that cant be modified. happens usually when the line is obtained via convert entities command. I know its probably something really simple and I run into this kinda thing every once in a while so i thought id ask this time.

thanks in advance.

 

[Theophilus]

uGlay, you must have a converted entities spline. Right? No trim for you.



Jeff Mowry

http://www.industrialdesignhaus.com

Reason trumps all. And awe transcends reason.

 

[meintsi]

One other note:
If you ae using the "convert entities" command on multiple edges on once, common endpoints will be constrained to each other.

Remember...
[navy]"If you don't use your head,[/navy]
[navy]your going to have to use your feet."[/navy]