When open STP directly what is the template that NX use? 1

[RubenSilva]

Hello

When i create a new Model, NX load the template: "model-plain-1-mm-template.prt" and if i import one ".stp" NX keep that template

But when i open one ".stp" file directly, without open a new model, NX dont load that template, but i dont know what template it loads.

Can someone tell me what is the template that NX load in this situation?

Ruben Silva
NX 1973

 

[cowski]

In the NX install directory you will find folders named STEP203UG and STEP214UG, these hold your settings files and the null part files that NX uses when you "open" a STEP file.

www.nxjournaling.com

 

[RubenSilva]

That's all i wanted

Thank you

 

[Toost]

You can set your desired settings in a new partfile, then save that in the directory that Cowski described and name it exactly as the existing files. ( rename the existing ones.)
then you get your setup in the imports.

Regards,
Tomas

The more you know about a subject, the more you know how little you know about that subject.