Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Why section views doesn't show diaØ symbol?

Status
Not open for further replies.

imti7

Mechanical
Jul 19, 2023
50
While drafting in NX 12 , its not showing ∅dia symbol automatically for cylinderical faces , please help with this, i just shifted to NX from soldiworks
 
Replies continue below

Recommended for you

Pick LINEAR DIMENSION, change to cylindrical. then pick the two lines for the silhouette of the cylinder.

Capture_um7lq7.jpg


Jerry J.
UGV5-NX1899
 
Thank you so much,

That worked!!
Thanks!
Imtiyaz
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor