sendithard
Industrial
- Aug 26, 2021
- 178
I've got this square callout for size then a position for said size.....I still don't remember much from the standard on this square drive symbol.
I measure both linear sizes independently and both positions independently. Seems simple and to the point. I measure both opposing planes as a planar position.
I've got an engineer asking me to output this as a normal hole-like position...asking me to create an axis b/w both midplanes and then a position callout.
Doesn't seem like acrazy request, but I'm curious your thoughts.
I measure both linear sizes independently and both positions independently. Seems simple and to the point. I measure both opposing planes as a planar position.
I've got an engineer asking me to output this as a normal hole-like position...asking me to create an axis b/w both midplanes and then a position callout.
Doesn't seem like acrazy request, but I'm curious your thoughts.
