Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in

Drafting Standards, GD&T & Tolerance Analysis

ksterling15
  • Locked
  • Question
Calculate Diametric Tolerance
Replies
4
Views
5
drawoh
drawoh
chelseasea
  • Locked
  • Question
The result of TA from CETOL and CAD
Replies
1
Views
2
3DDave
3DDave
Heleas
  • Locked
  • Question
MAX value given but also a general tolerance
Replies
6
Views
7
Heleas
Heleas
tw_0407
  • Locked
  • Question
Tolerancing of member prints (weldment/riveted assembly members) 1
Replies
5
Views
6
MintJulep
MintJulep
NDBM_
  • Locked
  • Question
Print considerations for castings vs fabricated parts
Replies
9
Views
10
jassco
jassco
DGN1975
  • Locked
  • Question
profile on trimmed edge 8
6 7 8
Replies
144
Views
145
ewh
ewh
sendithard
  • Locked
  • Question
Simultaneous position and establishing a clocking datum 1
2 3 4
Replies
76
Views
77
Burunduk
Burunduk
ETUDEN
  • Locked
  • Question
Complex geometry, do my datums make sense?
Replies
4
Views
5
Tarator
Tarator
Woosang
  • Locked
  • Question
DRF establishment with an inclined hole as a datum feature
Replies
7
Views
8
Tarator
Tarator
Wuzhee
  • Locked
  • Question
Irregular square-like feature. Square symbol applicable or not? 1
2
Replies
22
Views
23
Wuzhee
Wuzhee
Wuzhee
  • Locked
  • Question
Spherical vs diametrical tolerance zone 2
Replies
7
Views
8
sendithard
sendithard
taraskaz
  • Locked
  • Question
permissible angular deviation
Replies
3
Views
4
cr7
cr7
Woosang
  • Locked
  • Question
Coordinate system in MBD 1
2
Replies
28
Views
29
drawoh
drawoh
JimmyOon
  • Locked
  • Question
Parallelism + Square on the slot? 2
Replies
5
Views
6
DanStro
DanStro
Diametrix
  • Locked
  • Question
Cylindrical feature primary with surface secondary, what is the point?
Replies
6
Views
7
pmarc
pmarc
rollingcloud
  • Locked
  • Question
Any room for improvement on this drawing?
2
Replies
26
Views
67
pmarc
pmarc
renasis
  • Locked
  • Question
Two separate 4 hole bolt patterns, same angles, different diameter. 6
Replies
12
Views
13
geesaman.d
geesaman.d
rkrz
  • Locked
  • Question
GDT on machined extruded part 1
2
Replies
22
Views
23
3DDave
3DDave
renasis
  • Locked
  • Question
Circular thru bolt pattern, set position of coincident reliefs opposite side of part 1
Replies
1
Views
3
3DDave
3DDave
rollingcloud
  • Locked
  • Question
Is datum A-B still practical when the corresponding bearing surfaces have different sizes? 2
Replies
5
Views
6
rollingcloud
rollingcloud
You must log in or register to post here.
Back
Top