Recent content by Hesam267

Hi. The front side of pads (near shaft) is really important. But it is unlikely that the back part of the pads is not important, for these reasons: Suppose the curvature of the back of the pad is the same as the inner curvature of the housing, in this case the pads do not perform any tilting...

Hello. Friends, please help me in the design of the tilting pad radial bearing. I did not find any useful information about the curvature of the back of the pad in these bearings. Apparently, this curve is called backland. What are the design principles of this curve based on?

Hello everyone, I'm currently working on fitting a hydraulic press gear onto the main shaft of a gearbox, and I could use some guidance on the calculations and procedures involved. I'm looking for advice on how to properly calculate and execute the installation of a hydraulic press gear onto the...

Hi guys I saw a multistage centrefugal pump yesterday and two things surprised me. 1- one side of pump has radial journal sleeve and other side has two angular contact bearing with also radial journal sleeve too. Is it correct? As you know anti friction bearings don't have axial clearance and in...

dear Johnny if I'm not mistaken, stud is M16 and pressure of jack is 375 bar.

Thank you Johnny for your reply. please apologize me. Actually first we use special tool for tension stud according document value then tight nut normally. so we dont know any thing about elastic or plastic elongation. is it necessary to change stud in this state or not? thanks again

Hi guys I have a question about stud bolt of high speed impeller rotor. Actually we have high speed compressor (about 40000rpm) in our plant. After some year we change impeller due high erosion, with new one. We know amount of impeller torque of stud and because of high defection, it's tight and...

Hi guys i am a little confused in tilting pad journal bearing curves. i know concept of preload and design factors in pads curve in Babbitt side (shaft side actually) but what is radius of back of pads? (in attached file is named R out) as we know in pivot type, back of pads contact with...

actually our machine is old and non experts change its clearance before. i dont know any idea about ID (housing bore) but bearing OD is 110mm and CM said it has looseness in system. so dose it has any reference to determination clearance? what can i do?

can you Explained how i can measure crush? i heard two Definition about it. 1.it is clearance between top bearing and ID of housing 2.it is clearance between upper and lower housing while upper housing bolt tight with hand i know actual that two are same but what is your suggestion or prefer?

Hi friends. do you have any plot of bad bearing damping (tilting pad, simple journal, multi lobe ...). its interesting for me to know bad damping signs in vibration behavior.

Hi how can i design rolling element bearing for defined load and speed? absolutely it have limits and procedure. i need it for bear 200KN and 3000 rpm speed.

thanks Mr. Pellin probes area was a good point. its bearings are 5 shoes tiiting pad and its not show 1x and 90 degree phase (or 30 less or more). as i knew shaft unbalance observed on previous condition. may it different with different bearing type? tilting pad, 3 lobe, lemon type and etc.

thanks. its integral gear type. but bearings clearance and also bullgear and pinion backlash was checked and found OK.

Hi everybody i observed high speed compressor with high 7x (1x,2x,...,7x). machine semiopen impeller has 7 main blade too. this is my question: is it any relation? and what can rise all x? (x means 1rpm of rotor)