You are moving some expansion from the cylinder to the turbo. But you are also capturing expansion that otherwise would take place in the exhaust system (or at its exit).
Not so at all. Although it is true that some backpressure is added by the turbine, much of the energy driving the turbine comes from heat and impulse forces that are otherwise wasted as exhaust heat and noise. I would have thought that increased efficiency of turbocharged engines was a...
Another side note: In my experience, tires that are used regularly last much longer than those which are stored. I am not sure why this is, but having several times left tires unused for 1+ years, have found them invariably to be unusable after that, regardless of whether mounted or unmounted...
The process is this:
1) Identify geometrical limitations of the connection points at the frame and knuckle. Also identify desired suspension travel and available spring sizes, rates, and configurations. You will most likely want to use coilovers as they are easiest to package.
2) Identify...
I think the answer to your question is this:
For a given engine which operates naturally aspirated at a given peak CP, and with no additional limitations:
If we add a turbocharger which is at peak efficiency at this mass flowrate, and reduce compression ratio such that peak CP is the same, we...
"The presence of the restrictor, which actually accelerates the gases flowing through it and directs the air flow to the center of the turbocharger's compressor wheel, essentially increases the engine torque. We can roughly estimate the drop in engine power to be as high as 40% whereas the...
Hi guys,
I have another CATIA problem I am hoping someone can help me out with:
I need to do analysis on a complex weldment which is assembled from many parts. When the physical parts are assembled, they are jigged together which leaves gaps, the welder then fills these as he welds the...
^Edit:
The rotation problem had to do with a bad reference surface, and I fixed that. The stretching problem still exists. I am able to get appropriate geometry by making the target surface match the outside geometry of the initial surface, but this seems a lot of work to me. However, this does...
Thanks for the reply jackk. That did not work for me, as DL1 will only work with a revolute surface, and I cannot create one with the variable radius geometry above. This did point me in the right direction though. It seems the solution is the GSO toolbar, which has a 'wrap surface' option. This...
Also, FWIW, here is what the finished part should look like. I accomplished this by making a very thick pad and then using the split command I sectioned it with the required surface to make a thin contoured part. If I have to I can model the entire part this way, but I don't really think this is...
Hi guys,
I seem to have run into an issue that I can't figure out in Catia V5R21. I am working with a weldment that is made from many complex 2D sheetmetal parts which are bent to match each others' edge contours and then corner welded. Many of the bends involve variable radii. It seems as...
Ok, so if we can agree that surface effects dominate heat transfer in this situation, then the question becomes how accurately can these effects be represented using heat transfer calculations?
One little point, compositepro:
I am not suggesting 'adding' anything, what I am interested in is...
