Hey Mustaine,
As mentioned, I need to find the deflection at point (1)in the figure. That is, in my experiments the load is applied at point(1). The load distribution on the solid structure occurs as mentioned in the formulas at point (2) and (3). That is load isn't directly applied at point...
Hello,
I am trying to replicate the figure (1) loading such that I can apply load at one point figure (2) as I conduct in experiments.
The relationship between the loads are such that :
P2 = P*(a+b)/b and P1 = P*a/b where “a” and “b” are distances as shown in figure (1).
The main...
Sorry about the delayed reply. Yes the solid is in the final model too. There are two rigid wires which are tied to the solid. The MPC connectors are connected to the RP of those rigid wires. B.C's is such that the x face is fixed at the origin.
Hi,
I am having difficulty in using connectors. I have a beam where the load is being applied at two locations. I am trying to model such that load can be applied only at one location rather than two locations on the beam. I have attached a picture. I am trying to apply a single load on RP-3...
What is the difference between using a MPC link constraint between 2 nodes vs connecting the 2 nodes with a wire and then assigning a MCP link connector section to that wire? Will it give me the same answer during analysis ?
Thank you for the reply. I am trying to mesh a crack tip in a 3d modeling. I want to specify the number of elements, the shape etc. Which do you think is the best way to do that.
Thank you
Hi
the selected entity was created by an assembly level feature. For the model to generate properly apply all constraints before creating the assembly level feature error in abaqus. What does that error mean. I am trying to align the parts in assembly but not able to due to the error message...
HI
I wanted to know if you can extrude 2d mesh in width direction to create 3d models in abaqus CAE? I want to import a 2d mesh from a model i had done and wanted to know if i could extrude that 2d mesh to create 3d model?
Thank you
Thank you for the reply corus.
My crack length is 1/4 th the size of the beam. So how do you propose I model. Do I need to put a constraint between the surfaces if I do that the results I am getting are way off. How do you think I need to model to make my top and bottom surface of the crack to...
I have a seam crack in the middle of my material in x-axis direction. I am applying a compressive load in y at the center. I want the top surface of the crack to bend with the bottom surface without using interaction since it doesn't give me the required result. can anyone tell me what mistake...
In Abaqus CAE when I am modeling my top surface of the crack doesn't bend with the bottom surface of the crack, it interpenetrates with each other how to fix it. I can put constraints between the surfaces but that doesn't give me the right results. I am modeling delamination in composite material.
