Can someone please post the cut conditions for 3/16 CRS and 1/4 CRS. Feed, Power, Freq, Focal, ect. ect. I want to see where my conditions match with yours because im getting a poor cut. And also post your pierce settings if your able to spare the time. The pierce is blowing out and dont know...
haha i dont blame you we've been on 60+ hours a week here but thank you i was able to figure it out after your post and i was always wondering why if you use a different E code other than 1 it wouldnt change the focal point...
How do you change the the standard focal position? When M100 (laser mode on) comes up in the program, the focal point goes to .15 all the time, when most of my cutting i do is around .4-.6. Its very annoying and time consuming and in the operator manual, it says it can be adjusted in the...
Thats the thing is i do have a step by step on how to change them, but aligning them i dont, everything is on the internet now a days so i thought i would ask...I'll figure it out thank you for your time
I am in the process of changing/cleaning the mirrors on my amada and was wondering about alignment...When i am done cleaning the mirrors and replacing the bad one's, how do i go about making sure the laser is hitting in the middle of the focal lens again.
Also, any tips or cautions while...
drossfree,
What is your expierence with aluminum on your amada? I would love to start cutting aluminum but have no idea on what gas or settings i should be using, if you have any start point on where i could just get started that would be great!
Thank you for your time!
JW
My boss came up to me today and asked me if rubber could be cut on the Amada. Does anyone have any expeirence in doing so? Its definately rubber with an adhesive backing on it. We're trying to make gaskets for a company we do business with. The correct material name is Buna or Viton.
Thank You...
Thank you everyone for your time and information!!
Drossfree--I found your insight the most helpful and easy to understand.
(no offense to anyone else on here, I'm a beginner on the Amada)
But anyways I have ordered a bulk liquid nitrogen tank...close to 600 liters...until then I can only run...
Hello Everyone,
My company decided to go with an 1995 Amada Pulsar and I got thrown into the mix to try and get this machine running..
The Amada people have been here and got all the parameters and maintenance done to it and it's up and running. I know how to operate the machine I just need...
