Hi PatCouture,
I found workaround. export it to dwg, open dwg in SW. copy/paste required view back to original file.
It is not direct but not bad.
Thanks for help everybody.
Bhavesh
CorBlimeyLimey,
I want to quickly alter assmebly drawing to show better designs. I can always print & sketch over it but it won't be to scale & sometime confuse people in meeting. (crossing out line etc..)
It takes lot of time to change all parts in 3D to show various design enhancement...
I have migrated from Solidedge.
How can I convert a part view to 2D entities which I can edit with 2D commands like trim, extend etc..
I don't care if it looses the association with 3D part.
Hello, I am back to SW after 5 years, switching from SE ST3. Since it has been long, I need to get myself oriented to UI.
my first Q
in part, I'm trying to create anglular sketch dim. By clicking only innclined line, linear dim starts by default, how can I convert to angular?
Thanks
Bhavesh
"If you are applying dimensions to one dp then what does it matter if it's 10.3 or 10.5 - you will still have to measure to the same accuracy to check it"
It is different numbers 10.3 & 10.5 and you think it doesn't matter!!!!!!?????
Drawing Readed look at drawing NOT model.
I am creating drawing of a plastic component from an imported model, which I scaled in SE for shrinkage allowance. It is combursome first to change 100s of features & dim. in historyless model.
This is to me is a so basic thing, can be required at number of cases. I know 10 years ago AutoCAD...
This might be out of subject, but for same command "rectangle"
When selecting point on exisitng element as a corner, It doesn't create relationship by default. I have to relate it with "connect" after drawing rectangle.
How to round-off dim values to specific least counts (not to number of decimals)
For ex. if least-count set to 0.5, then
Actual size Rounded-off Value
10.3---> 10.5
10.2---> 10.0
Hi beachcomber,
It is not working either way. There is no "break line gap"
I have tried following.
Under Dimension Line
stack pitch: -1, -1.5 and other values
Break Line: (negative not allowed)
Under Projection Line
Element Gap: -1, -1.5 and other values
Extension: -1, -1.5 and other values...
In Draft mode:
I could not able to position angular dimension text where I wanted to. SE is restricting text position. Attached file explains it more.
Do anybody have solution?
Thanks
Hi Kenat,
Above stated threads are not based on any software, but I came across it when trying to achieve end result.
We should take one thread as an example instead of beating around bush.
thread562-188496
Full round blend
Try to achieve attached in any SE V20 or older.
Any method can be...
Scott,
Thanks for replying in detail. All 13 points are extracted from my previous threads for which I couldn't get solution. It would be better if we discuss this in same threads. Below is the thread reference numbers.
1. thread562-188496
2. thread562-187770
3. thread562-190577 &...