Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

4 leg sling

Status
Not open for further replies.
vscid

vscid

Nuclear
Aug 5, 2007
65
0
0
US
If I am using 4-leg wire rope slings to lift a load whose CG is offset from the pick point, would my load remain perfectly horizontal or would it tilt?
Thnks.
 
Replies continue below

Recommended for you

Sort by date Sort by votes
ok, the load is at the CG of the piece ... what's stopping you from moving the lift point so it is directly above the load CG ?
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

struct_eeyore
  • Locked
  • Question
3/4" metal roof deck
Replies
4
Views
20
DanKile
DanKile
dockofthebay
  • Question
4 Story 3-Unit Residential in San Francisco
Replies
2
Views
20
dockofthebay
dockofthebay
mtuhusky
  • Question
4-Sided Open Face Wood Frame Diaphgram - Wind Design 1
Replies
9
Views
69
Eng16080
Eng16080
wb.c
  • Locked
  • Question
Angle with load on leg - bending analysis 1
2
Replies
30
Views
31
WesternJeb
WesternJeb
Veer007
  • Locked
  • Question
Inquiry: Use of 3/4" Ø Bolt for 4" Wide Beam 3
Replies
11
Views
34
dik
dik
Back
Top