Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations pierreick on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

ANSI Pump Allowable Nozzle Loads Vs Actual Loads

Status
Not open for further replies.

az5333

Mechanical
Dec 3, 2020
60
Hi fellow experienced Engineers,

I am doing a stress analysis for an exsiting piping connected to an ANSI horizontal pump that has given allowable nozzle loads / moments for the suction and discharge nozzle. I am consistently getting very high Fb and Fc for the operating cases (high temp and low temp). SUS case and HYD case are both within allowables. I have been playing around with supports here an there but looks like the loads stay around the same value and are very high (Fb and Fc). Any ideas how can I control these and what to look out for in existing piping design? Thanks
 
Replies continue below

Recommended for you

Could you post a picture of your system? Are you checking allowable loads by hand or with the Equipment Analysis tool?
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor