Drawing border template

[TechnicalConsultant]

Good morning everyone,

I'm hoping someone can help with this, a drawing border template has been created and parts of it have been done using sketching. The problem is when I now go New-Drawing and select it when it appears on my screen the sketch is active.

Any thoughts appreciated.

 

[MickyV007]

Open the template , goto drafting module, close the sketch environment, SAVE the template.


Best regards,

Michaël.

NX7.5.4.4 + TC Unified 8.3

 

[TechnicalConsultant]

I tried that but it still starts up in sketcher

 

[TechnicalConsultant]

I'm also getting another weird issue The template has attributes in like this (<W@DB_PART_DESC>) which work fine. However, when I add them to older drawings use File-Import-Part then selecting the template some of them go a bit strange (see below)

<WUGII-UGII-ANON-5.PRT@?BDR_TITLE2>