Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Drawing question - Dimensions 5

Status
Not open for further replies.

JakeyTGS

Automotive
Joined
Nov 10, 2023
Messages
2
Location
GB
I am looking for advice regarding a drawing I am currently working on.

Capture_ipsvqp.jpg


How could I annotate on the drawing that the dimensions on the left pillar are the same as the right pillar?

I was using the TYP abbreviation next to the dimensions however I read that this is no longer used as a standard.

Is there any other way of doing this or do I need to add the same dimensions on the opposite face of the drawing.
 
You could simply extend the dimension lines to the elements on the other side.
 
Use a notation such as "2X" next to each dim.
 
Is this a case of Continuous features?
Because if it is, then showing the extension lines do not indicate a CF. Either a number like 2X or the CF symbol should be used.
 
Thank you all for your feedback. I Appreciate your help.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top