gabimo
Mechanical
- May 2, 2013
- 124
ASME Y14.5-2009/ page 15
1.8.2 states: Where the center of a radius is not dimensionally located, the center shall not be indicated.
Fig 1-30 ASME Y14.5-2009
Why the center of the radii are indicated?
Aren't they shown by the two small crosses?
1.8.2 states: Where the center of a radius is not dimensionally located, the center shall not be indicated.
Fig 1-30 ASME Y14.5-2009
Why the center of the radii are indicated?
Aren't they shown by the two small crosses?