Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations The Obturator on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Flatness tolerance 3

Status
Not open for further replies.
waqasmalik

waqasmalik

Mechanical
Jul 18, 2013
177
Attached figure has been taken from the Alex Krulikowski book of GDT Fundamentals.
My answers are 0.4 for both blanks.Am i right?
 
Replies continue below

Recommended for you

Sort by date Sort by votes
waqasmalik (Mechanical)is talking about the maximum permissible flatness for both the faces & it is 0.4
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

V
  • Question
Why flatness tolerance associated with a FOS must be less than the size tolerance? 1
Replies
8
Views
3K
drawoh
drawoh
Gavin_yang
  • Locked
  • Question
RSS Tolerance Questions! 2
Replies
7
Views
3K
Gavin_yang
Gavin_yang
greenimi
  • Question
Runout Tolerance Applied on an Assembly 1
2 3
Replies
55
Views
5K
greenimi
greenimi
Mech1595
  • Locked
  • Question
ISO - Flatness CZ of Offset Features
2
Replies
20
Views
927
Woosang
Woosang
PtoMonty
  • Locked
  • Question
Position tolerance datums 3
2 3
Replies
42
Views
2K
PtoMonty
PtoMonty

Part and Inventory Search

Sponsor

Back
Top Bottom