May 17, 2005 #1 Uka Mechanical Dec 15, 2003 46 0 0 US I added hatch to drawing, however, it doesn't show when you print. What can I do to print it on a paper? Thanks,
I added hatch to drawing, however, it doesn't show when you print. What can I do to print it on a paper? Thanks,
May 17, 2005 #2 SBaugh Mechanical Mar 6, 2001 6,684 0 0 US Does it show up in the print preview? If so then it's your print driver. Regards, Scott Baugh, CSWP 3DVision Technologies http://www.3dvisiontech.comhttp://www.scottjbaugh.comfaq731-376 faq559-716 - SW Fora Users Upvote 0 Downvote
Does it show up in the print preview? If so then it's your print driver. Regards, Scott Baugh, CSWP 3DVision Technologies http://www.3dvisiontech.comhttp://www.scottjbaugh.comfaq731-376 faq559-716 - SW Fora Users
May 17, 2005 Thread starter #3 Uka Mechanical Dec 15, 2003 46 0 0 US No, it is not even shown in preview... Would it be still print driver?? Thanks, Upvote 0 Downvote
May 17, 2005 #4 CADGemini Mechanical May 12, 2004 481 0 0 US Just curious what Version and SP are you using? It might be worthwhile to upgrading to the latest SP. Best Regards, Jon Challenges are what makes life interesting; overcoming them is what makes life meaningful. Solidworks 2005 SP3.0 Upvote 0 Downvote
Just curious what Version and SP are you using? It might be worthwhile to upgrading to the latest SP. Best Regards, Jon Challenges are what makes life interesting; overcoming them is what makes life meaningful. Solidworks 2005 SP3.0
May 17, 2005 Thread starter #5 Uka Mechanical Dec 15, 2003 46 0 0 US Yea, you were right, jksolid. I upgraded to the latest SP, and it fixed the problem!! Thanks, Upvote 0 Downvote