How to control 4 cylindrical pockets 2

[Rwelch9]

Hi guys,

Can anyone point out any flaws you see with these call outs on this drawing.

The idea is the best way to control and dimensions 4 Cylindrical pockets / with the front and back being as close as coaxial as possible.

Thanks

Ross

 

[Rwelch9]

Yes i was not sure about this myself .

However if the drawing is correct in terms of the use of the simultaneous requirements methodology.

Obviously this is a very small portion of the drawing you guys are helping me with .

The reason I kept Datum B + C

I was going to use them Secondary and tertiary Datum

Also the outside profile of this part has a surface of a profile to Datum B .

This one of the main reason i am struggling with this part as i am trying to control these 4 pockets and also use them as a Datum . As there not much else functional on the part .

Thanks

Ross