Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
I-deas Drafting to NX
- Thread starter hrhett
- Start date
It can be done with the Content Migration Manager. It's free and really not that tough to set up and can be done w/o teamcenter.
Drawings seem to come over fine. I have used I-deas extensively and only dabbled in NX. But i did transfer a decent size assembly and all the part and related drawings. If i changed a migrated part the drawing updated. I have never made a part in NX and an associated drawing from scratch. Figured i could figure that out later if we converted to NX.
Drawings seem to come over fine. I have used I-deas extensively and only dabbled in NX. But i did transfer a decent size assembly and all the part and related drawings. If i changed a migrated part the drawing updated. I have never made a part in NX and an associated drawing from scratch. Figured i could figure that out later if we converted to NX.
187lockdown
Industrial
Suugest talking with TEAM Engineering, they looked after our transfer of data to NX. Website
- Status
Similar threads
- Question