Large Diameter Bar

[emay]

I need an ASME material specification for a bar of 14 inches diameter. It is for a Hydraulic swivel that will be built and analyzed to ASME BPVC.
Can anyone send a suggestion?
Thanks! -Ed May

 

[gr2vessels]

ASME SA 105, refer Clause 4.4
cheers,
gr2vessels

 

[emay]

gr2vessels,

Thanks for the prompt reply!

I was hoping that there was a Bar specification. SA105 is a forging specification... SA-105 also doesn't have a Clause 4.4 which means I'm looking in the wrong book?

I'm looking in 2007 Section II, Part A, SA-105 section 4., page 200.

Basically, I'm looking for the easiest way to get a piece of material that's 14" dia by about 16" long.

Thanks again!