Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Machined thread strengths 1

Status
Not open for further replies.

JasonEm

Mechanical
Aug 21, 2003
8
CA
Hello Members,

I am searching for a good site or reference material to help calculate the pull out strength on a threaded section that will be machined into a part. It will terminate in a Grade 8 Nut so I am not as concerned with the nut strength as I am with the machined section.

Thanks
 
Replies continue below

Recommended for you

Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top