Memory Errors!!

[jzn1s3]

Everyday I receive low memory error warnings 30% 20%....... then the systems eventually crashes, happens a bout three times a day. Are there any preferred settings they need to be set? I have attached my system information, does this look normal or does something need to be tweaked to gain better performance?

Thanks,

Brian

 

[JohnRBaker]

That looks more than adequate, for a 32bit configuration. Now unless you are attempting to load mega-Assemblies (1,000's of parts) or the models are very complex (lots of free-form faces and complex shapes), it could be hardware problems (are you running any other memory intense applications simultaneously with NX?). Have you tried this on another similarly configured PC?

If this continues, I recommend that you contact GTAC and at least provide them with some syslogs of failed sessions.

John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA

http://www.siemens.com/plm

http://www.plmworld.org/museum/

To an Engineer, the glass is twice as big as it needs to be.

 

[bboy68]

Hello


Did you watch the management of virtual memory in windows option, the option must be sized to manage the system, there may be problems if it is managed manually

 

[looslib]

You only have 3GB of memory installed. Try increasing it to 4GB ad use the /3GB switch in your boot.ini.


"Wildfires are dangerous, hard to control, and economically catastrophic."

Ben Loosli