NJ PE Seal-Metal or Rubber

[wylasce]

I would like to know if I should get a metal type embossing seal or rubber type seal. NJ Board says that metal deal is the arthorized seal.

I want to check with other NJ PE to say what kind of seal you guys got since it is difficult to make photocopies of drawing of the embossing seal.

 

[MiketheEngineer]

That's the idea - you CAN'T photocopy the seal!!

 

[shin25]

Only the metal embossing seal is accepted by the NJ board.

 

[DonPhillips]

I do not have an NJ license but when I pick up a state, I tend to order both.

Don Phillips

http://worthingtonengineering.com

 

[MarcbSE]

To my knowledge only the embossing seal is permitted in NJ. That is the only type of seal I have for NJ.

 

[bridgebuster]

To photocopy the embossed seal, rub over it lightly with a pencil.

 

[wylasce]

Thank you for your guy's input. I think I will just order a metal embossing type seal first. BTW, do you guys put No."GE xxxxx" on you seal or just No."xxxxx"?

Also where do you guys order those diploma-like wall ceritficate?

Thanks,

WYLASCE

 

[archeng59]

I put the GE with my number. I crimp seal copies of the original drawings and hope the architect doesn't want very many copies.

 

[wylasce]

Thanks.

should we use "GExxxxx" or "24GE0xxxxx00" on the seal?

Sorry for this non-technical question.

 

[MarcbSE]

My crimp seals starts with "GExxx". I was told by the state board that the leading "24" was not needed on the seal.