Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

NX11 on Windows - Java prerequisities?

Status
Not open for further replies.

icetea73

New member
Apr 10, 2013
53
I'm about to install NX11 on Windows7. Which JRE is required? 32bit or 64bit?
Spend at least an hour searching in the documentation, release notes and any other Document available without finding any answer... :-(
Thanks in advance.
 
Replies continue below

Recommended for you

64 bit version is required for NX.

Anthony Galante
Senior Support Engineer


NX3 to NX11 with almost every MR (24versions)
 
I experienced some issues with the document server and GTAC recommended a specific version. Sorry, I don't recall what version they recommended but that issue was a while ago so I would try looking it up in the Siemens knowledge base or call GTAC of you cannot locate it. However, when I was experiencing my doc server issues, I was running the latest java version at the time and it ran fine except and I only had issues when I switched computers for the server.

11.0.1
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor