NX11 Sketch Options 2

[John2025]

Hi all,
We're upgrading from NX10 to NX110 and of course there're some challenges. When I open Sketch(Direct or Task) the new window doesn't have the same kinds of options as before. In NX10 we could choose a plane and then choose direction and origin options. In NX11 it's just pick a plane and get what it gives you. Any way to get the NX10 options in NX11?
John

 

[John2025]

Never mind. Picking "New Plane" gives the options I was looking for.

 

[PSI-CAD]

Hi
All options are within the roll down menus

Regards
Didier Psaltopoulos

http://www.psi-cad.fr

 

[RuudvdBrand]

Dear John,

I think the tool is working better then before. It's not necessary to switch the plane method to new plane. From the inferred you can reselect also your new plan, horizontal reference and origin point. See movie.





Ruud van den Brand
NX pre-sales Consultant
cards PLM Solutions B.V.