Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

NX1926 - Drafting Settings Question

Thread starter BrittToolEngineer
Start date Mar 24, 2021

Status: Not open for further replies.

Mar 24, 2021

BrittToolEngineer

Aerospace

Greetings:

I'm new to the NX1926 version. When drafting, my centerlines come in at a 25 thickness. I would like to change this in settings, but have not been able to find it yet. Can someone help point to where we change this setting?

Thanks,

Brent