May 21, 2007 #1 bosoxme Aerospace May 24, 2006 7 In NX2 you can check mass properties by face....Where is it in NX4? It only allows me to pick solids. Thanks in adv advance.
In NX2 you can check mass properties by face....Where is it in NX4? It only allows me to pick solids. Thanks in adv advance.
May 21, 2007 #2 phillpd Mechanical Oct 19, 2006 780 Analysis->Measure Face is what I think you're looking for. If you're new to NX4 then it maybe that the "Role" you're currently using doesn't show this option. Try changing to one of the "Advanced" Roles. Specialty Engineered Automation http://www.sea4ug.com Upvote 0 Downvote
Analysis->Measure Face is what I think you're looking for. If you're new to NX4 then it maybe that the "Role" you're currently using doesn't show this option. Try changing to one of the "Advanced" Roles. Specialty Engineered Automation http://www.sea4ug.com
