NX6 Face Selection problem

[femboy]

Hello. I've a part model contains of faces. But I cannot select face that I want. Are there an option in NX6 about it? Did you faced a problem like it?

 

[hudson888]

Place your mouse in the right proximity and using MB3 choose select from list. If it doesn't work first time then set you selection filter to faces.

Best Regards

Hudson

www.jamb.com.au

Nil Desperandum illegitimi non carborundum

 

[jerry1423]

Does it look correct when shaded?
It could be a sheet instead of a solid.

 

[femboy]

Thank you for your response. There's no solid in my model. Faces are seen as body in tree. I place my mouse a face that I want to select. While I can select some of faces, the others can't been select

 

[jerry1423]

Unblank everything.
Make sure all the layers are selectable.

I have had some models (done overseas "east") where they used "visible in view" in the model - make sure there is none of that in your model.
Format > visible in view > reset to global ... you may need to do that for all the canned model views