Orthograhic Views in MDT2004

[gregL3]

I just started using MDT 2004, and for some reason the orthographic views are displayed showing the other side of the base view. In other words, if I project an ortho view on the left side of the base, it actually displays the right side. I'm assuming it has something to do with the UCS, but I can't figure it out. Anyone come across this?
Thanks.

Greg
Williamsport,PA.

 

[gregL3]

I found the answer to my own question. But if anyone else encounters it- the system variable "amprojtype" was set to 0 enabling 1st angle, rather than third angle projection.