Spaceball Settings

[GladwinJay]

Has anyone had issues with NX 2 not keeping you 3D input device settings?

I am using a spaceball 4000 flx. And even if I set all sensitivity buttons to max it is still slow in NX 2. Then when I adjust the setting in UG it will only keep the setting in that session.

Any suggestions?

Thanks

 

[Simon99]

In the ug_metric.def (or ug_english.def) enviroment file search for the spaceball sensitivity:

UG_3DInputSensitivity:

If you increase this value it should increase the default sensitivity. We run on 6 as default on our 3000/4000/5000's on NX2.

The new USB spaceballs seem to be much more sensitive out of the box that the serial ones...

Hope this is some use.

Simon C