BrittToolEngineer
Aerospace
Greetings:
Attached is a pic to help with my issue. I have an extracted face sheet body with a missing section in one corner due to part geometry. For the trim body, it would be nice if these would be a square sheet. Is there a quick command to delete the edge and have the sheet body come out to make the square corner?
Thank you in advance for the help.
Brent
Attached is a pic to help with my issue. I have an extracted face sheet body with a missing section in one corner due to part geometry. For the trim body, it would be nice if these would be a square sheet. Is there a quick command to delete the edge and have the sheet body come out to make the square corner?
Thank you in advance for the help.
Brent