Trim Body Edit Tools

[BrittToolEngineer]

Greetings:

Attached is a pic to help with my issue. I have an extracted face sheet body with a missing section in one corner due to part geometry. For the trim body, it would be nice if these would be a square sheet. Is there a quick command to delete the edge and have the sheet body come out to make the square corner?

Thank you in advance for the help.

Brent

 

[Blase_McK]

Have you messed with the move faces tools?

Thanks
Blase

 

[BrittToolEngineer]

I have not yet. But I did figure out that I can extend the edge in 3 places for that cutout, and as long as my extend value is larger than the radius of the circle, it brings it to the corner as I desired.

I appreciate your feedback.

Thanks,

Brent

 

[Blase_McK]

Thanks
Blase

 

[Toost]

Delete Edge ?

Regards,
Tomas

 

[BrittToolEngineer]

Delete edge works perfectly as well. Thanks Tomas.