bhollehday
Mechanical
- Nov 13, 2019
- 14
I cant figure out a way to get multiple components to be mirrored while keeping the same name and position as the original component. If the pattern component feature had linear, circular, reference, and "mirror" it would solve my issue.
I want to drive a parts list in the drawing of a large assembly, but currently have a lot of components mirrored to the other side of the assembly using an associative mirror. The associative mirror tool forces a new name on the components being mirrored. Now I have trouble in the parts list for showing correct quantities.
Any ideas here? I came from CREO where you could easily make this happen and drive a BOM.
I want to drive a parts list in the drawing of a large assembly, but currently have a lot of components mirrored to the other side of the assembly using an associative mirror. The associative mirror tool forces a new name on the components being mirrored. Now I have trouble in the parts list for showing correct quantities.
Any ideas here? I came from CREO where you could easily make this happen and drive a BOM.