Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Circular thru bolt pattern, set position of coincident reliefs opposite side of part 1

Status
Not open for further replies.
renasis

renasis

Mechanical
Dec 29, 2002
56
I have a 4 hole bolt pattern, 90 deg apart. I know how to set position these holes realative to datums A, B and C. The problem I am not sure about is how to set position on bolt releiefs (in side wall) that need to be concentric to these holes on opposite side of part. Do i need to create datum on each hole? Set each relief position relative to corresponding hole? Seems pretty repetitive for a simple requirement. Any advice on this?
 
Replies continue below

Recommended for you

Sort by date Sort by votes

For your use, see

fig10-27_i52vkg.png


Alternatively since the bolt heads are located no differently than the bolt bodies, use the same DRF [A|B|C] for them as well with an appropriate tolerance and clearance.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

jimbod20
  • Locked
  • Question
Position Tolerance - Hole Pattern 1
Replies
19
Views
183
Burunduk
Burunduk
Azeemsha
  • Question
Call out for a pattern of concentric holes
Replies
10
Views
3K
Ryan6338
Ryan6338
SDETERS
  • Locked
  • Question
Position and orientation of slot
Replies
6
Views
170
jassco
jassco
Joel_Lapointe
  • Locked
  • Question
Bad drawing conversion (hole pattern asymetric position) 1
Replies
9
Views
126
3DDave
3DDave
Mech1595
  • Locked
  • Question
ISO GPS - Position & Profile of a Surface
Replies
10
Views
144
SeasonLee
SeasonLee

Part and Inventory Search

Sponsor

Back
Top Bottom