Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Gear and Pulley engineering

Starker
  • Locked
  • Question
Inventor: Apply Gear Parameters to Existing Geometry
Replies
0
Views
50
Starker
Starker
ElMicha
  • Locked
  • Question
Power Transmission: Input Pulley Speed 2
Replies
8
Views
183
Strong
Strong
lucadueberto
  • Locked
  • Question
Unknow profile shift coefficient
Replies
4
Views
126
lbmakem
lbmakem
charls1
  • Locked
  • Question
helical gearbox calculation
Replies
8
Views
174
Tmoose
Tmoose
Garrett Green
  • Locked
  • Question
Timing shaft Stress concentration
Replies
3
Views
158
Garrett Green
Garrett Green
Shubhm139200
  • Locked
  • Question
Worm gear zi
Replies
10
Views
231
BrianE22
BrianE22
EGKSi
  • Locked
  • Question
JIS Spline Standards
Replies
5
Views
339
dbooker630
dbooker630
moideen
  • Locked
  • Question
Interval between Gear Box Oil Replacement 5
Replies
10
Views
266
Tmoose
Tmoose
charls1
  • Locked
  • Question
ratio gearbox and kw motor
Replies
4
Views
107
dvd
dvd
rollingcloud
  • Locked
  • Question
What type of fit is this internal spline? 1
Replies
9
Views
153
rollingcloud
rollingcloud
rollingcloud
  • Locked
  • Question
Some confusing questions on splines 2
2
Replies
32
Views
379
rollingcloud
rollingcloud
John2907
  • Locked
  • Question
Looking for the z-13 spline
Replies
5
Views
165
3DDave
3DDave
rollingcloud
  • Locked
  • Question
Is there a reason to have slightly different lead crowning on left & right flanks of external sp
Replies
8
Views
159
rollingcloud
rollingcloud
aldumoul
  • Locked
  • Question
Belt Pull Calc
Replies
4
Views
93
aldumoul
aldumoul
Mande Mandiri
  • Locked
  • Question
Attaching Shaft to Plastic Gear Without Shaft and Screw Hole
Replies
10
Views
250
aMengel
aMengel
gcarmich
  • Locked
  • Question
Force on gear tooth calculation based on HP and RPM
Replies
1
Views
92
mfgenggear
mfgenggear
jared1313
  • Locked
  • Question
Torque needed to maintain a constant fall velocity
Replies
4
Views
137
TheTick
TheTick
spigor
  • Locked
  • Question
Correct term for project implementation 1
Replies
3
Views
67
desertfox
desertfox
moideen
  • Locked
  • Question
oil splashing gearbox 1
Replies
3
Views
55
geesaman.d
geesaman.d
JD P.E.
  • Locked
  • Question
Metric Gear Design Question About Dedendum 1
2
Replies
23
Views
216
JD P.E.
JD P.E.
You must log in or register to post here.

Part and Inventory Search

Sponsor

Back
Top Bottom