thanks, this is what I thought beforehand and was confirmed by the mill. They missed a charpy requirement and now we need to retest various heats. Thanks for the response.
If there were multiple diameters of bar made from the same heat at a mill, would the mill perform a Charpy test on each individual diameter bar or would they just test one representative sample from the entire heat/lot? Meaning would they machine the same size charpy sample from two different...
Is there a formula to figure out how much stresses would come into play when bending a solid 5/8" non ferrous bar, specifically n04400? I want to know if it would crack?
In a piping system that will have 36% HCl ran through it and then purged with air and then 6% HF run through at ambient temperature, would you expect any issues using C276? Or possibly another alloy? I am thinking C276 just because its resistance to HCl but not so sure with the HF, I know it is...
If a there were an acid mixture containing( Nitric, Sulfuric and Hydrochloric) what would the corrosion behavior of the mix be? Oxidizing? Reducing? I don't have any concentrations yet. The obvious thing would be that the acid with the biggest presence would take precedence over the others, is...
Yea that's the problem the material is already in transit. I have heard that a dilute muriatic acid solution would wipe the material clean from grime and oils. I agree that this is poor workmanship if incomplete pickling has occurred.
It sounded a little sketchy. I actually think the markings on these tubes may be a result of incomplete pickling. I am waiting on a response from Haynes to see about their process.
I have some tubes, with some tarnish and handling stains on it, I have heard from a colleague that you can use a dilute muriatic acid solution to wipe away the grime. Has anyone ever heard or tried this?
I have some Alloy C22 that has some blackish stains around the length of a tube. The pipe looks smudged and foggy and the dark stains are not in any particular pattern down the length of the pipe. If they are pickling stains, this would not affect the corrosion resistance of the pipe, correct...
I know K500 is made to QQN286 Rev E,F or G, and ASTM SB 865. But someone is asking about ASME Code Case 1192 in regards to K500. I do not know what is meant by this, any thoughts? Does it reference the chemistry or mechanical properties, like B865?
All I have on this media is an MSDS, no temperature. Does anyone know of somewhere I could find some data on how this media attacks. I haven't been able to come across this, but I know it is very nasty and caustic. I have found some information on Toulene, but not toluene contaminated with DCA...
ha, yea it makes sense. I believe it was a south American customer and someone probably just stuck the message in a online translator and out came "laminated". Thanks the insight folks!
Has anyone ever hear of Laminated C276 bar? I have someone asking for this and I have never seen this. He is also asking for hard/stripped solubilized. Are these surface treatments or something, or is this guy just confused?
