Hi all
in ABAQUS example problems manual, 1.3.7 Axisymmetric forming of a circular cup. i tried to run the axiform_sprbk1.inp but it could not because "no import file was specified"!!!ofcourse i have already ran axiform.inp.
Please tell me how to specify the import file.
Best regards!
Phanhung
Thanks corus
Four parts of my bus is two sides left and right, up and down floor. Each parts include many components (it is a car frame with thousand of components). For eacg parts i have done many things, such as partition, tie, coupling, mesh. I can not merge the model because each component...
Hi all
My bus model is so completed so i divided it into four parts for many people solve it to save my time, but problem is that after finishing fours part, i realize that i can not assembly all of together. Please tell me what should be done in this case to save all the thing i have done in...
Hi
thanks you very much, i will try it, i have read "restarting an analysis" many times, but i didn't know how to deal with my problem!
Best regards
Phanhung
Hi
Sure that i have .res, i got result for first 1 second. And now i change the time period to 2, and the problem is that i don't know how to continue my analysis without starting from the beginning. How to run the analysis and which is the command format to run it or something else i have to...
Hi
i am working with dynamic/explicit problem, the analysis took me a long time. I got the result in 1 second, and now i want to increase the time into 2 seconds, if i start to run from the begining, i take a lot of time! i would like to run my analysis after frist 1 second, how should i do.??
Dear
1. First, you can not see the result, althought you see running comeplete. Actually, the computer do not know what to calculate, so only complete for imputting the file, not for calculating.
2. When you request for hisory, error massege appear, it tell you that your model have some...
Dear
You see, in crack propagation analysis, we have three way to model (please take a look in ABAQUS MANUAL), and in each method, we have to define some parameters and these will affect to the crack propagation. Such as Normal failure stress, shear failure stress (with CRITICAL STRESS), or...
Dear
i don't understand for the deformation plot factor, and don't know where to check it? anyway, my problem close to ex "crusing of tube" in ABAQUS/explicit: keywords. I do the same thing for my model, the above problem happened. I come back to do again ex by ABAQUS CAE, the tupe also freely...
Dear
Sure that i have checked all of it before i asked for help. I have defined a contact pair between the regid body and the bar, also checked the surface normals. But the prolem still happen.
i do not know what should be try next????
Thanks
Dear
I have done with it before, and i got the same problem. Then i see that, the load will not effect much to propagation of crack. Just take a look at the others parameters when you define this step.
Dear
i am working with IMPACT analysis. i model a bar with velocity v, touch to a rigid body. My problem is that, the bar freely go throught the rigid body. it seem there was no any impact. What's problem???
Hi
i have the velocity 0.2mm/s, and the total time for experiment is 97.5 sec, and the displacement is 19.5mm. I set up the boundary condition type=velocity 0.2mm/s, the time in stactic step is
Static
97.5, 1, 1e-05, 1
But in the result, i got the displacement is 40mm (not 19.5mm). I think...
Hi
Thanks Bassmanjax, i did it, but i still can not get the curve after the time 1.55, because it is total time, anyway, in ex they have the curve after the time 1.55. How to deal with.
Thanks
Phanhung
