I just pulled a dxf off of one of our suppliers web sites in dxf format. when I pull up the drawing (in dwg format) and try to get a diminsion between two holes it comes out in cm. In the dim style manager box, under primary units the unit format is Decimal. My question is how do I made my...
open your .dft file and do a save as, change the as file type to .dwg and it should come out fine. I usually get a message about proxy graphics but just click ok and dimensions and lines should show up correctly. I have done this on both version 11 and version 14 of solidedge. I hope this helps...
Is it possible when in the draft enviroment to create on hole table, on a seperate page for all of the previous views/pages. For example I am working on a 4 page drawing. I have a front, left , right, and top view. I want to add a page 5 with a hole table for all the previous pages. Any help...
Using solid edge 14 service pack 5. I get a grey arrow pointing to a cutout when I go back before that cut out and make a change to a profile I am getting this error message a lot. the cutout or protrusion that I get an error on seems to me to be non associative to the one I modify but I still...
this guy offers on site training and also classes. We have used him and were very pleased. Here is the link to his site. http://www.cadcamtraining.com/
I just up graded SE11 to SE14 and the first thing I noticed was WOW, THOSE ARE SOME BIG OLE BUTTONS!! :-) Is there any way to make them smaller, I know that their was in SE11 but I either can't remember it or can't find it.
Thanks,
DKDragon
No offense taken, thank you for the explanation. This forum in my opinion is a very valuable tool and I just wanted to be sure I wasn't unknowingly abusing it.
Thanks again,
DKDragon
Thank you swertel, thats not the setting you can click to make it happen automaticaly, but i believe it will work just as well and I appreciate it. I have one more question for you,on the last 2 msgs that I have posted the replies i have gotten have said toward the end "Please see...
What is it that you go in and change so that when in an assembly, and adding a part from the pathfinder you do not have to specify any relationships, just choose the arrow tool and SE grounds the part, even if its not the first part placed?
Thanks,
Dkdragon