Hi,
I have made a part on the top plane, but now i see that the front plane would be better.
I know that there must be a way to change a part from an plane to an other, but how?
thanks
Toolmaker
I have 2008, I can't send bakc the file for you.
Edit the first sketch, dim the arc, make both arcs equal.(done)
Select the corner on the origin and remove the coincident.(done)
Add a horiz centerline thru the center of the part mid-point to mid-point.(done) Make the mid-point of this line...
Riiiight, I had to add 2 centerline sketches( one horizontal & one vertical?) and add relations to the origin(yes, but how?), then remove the original relations of the sketches to the origin and add relations to the original sketch to the new centerlines using Symmetric relations. Catch all...
Hi,
SW version 2007
in (extrude 1)I have a sketch in witch I want to relocate/move the origin from the left corner to the middle of the sketch.
I first tried the following: Click Edit sketch/in the sketch I click on the origin, and (in the existing relation box) I selected the coincident o...
Hi,
I want to make an angled cutout in an assembly.(two parts)
I have two cylindrical tubes concentric in an assembly that I want to cutout in an angle.
Is there a way to make the cutout as you would do normally if these parts were one piece?
Because of the angle it is hard to do it in the...
ctopher/MadMango
Right-click on the surface, change color doesn’t work, so I made a Cut-extrude feature of my assembly. After this I tried to change to colors of the cut components, no problem changing the color of the parts in the assembly, but what I want to do,is to color the face that...
I need to make a threaded hole through the length of a cylinder
Cylinder diameter 50mm
Cylinder length 40mm
Threaded hole 1.250-18 (through all)
Am I correct that 1.250 is the diameter , and that 18 is the pitch ?
I have never worked with inch before, so how do I select this 1.250-18 thread ...
Hi,
I have opened a part from witch i want to make a drawing,when i go to file i click the make drawing from part button,i can drag the part view from the right side of my screen into the drawing sheet.
the problem starts when i want to dimensioning the part, for some reason i can not...
Thanks Jeff,
This is a great ” simple” answer to a my question ,especially because my “Solidworks technical English “ needs to learn a lot, so when I go to the SW help section, often the answer is more difficult to understand than the question!!
But thanks to the upload’s we can communicate...
Hi,
Hoping that my part is posted correctly, and can be opened to explore / experiment with.
The fillet needs to be at the end of the ( cut extrude 2 & mirror)
Yes i have tried smaller fillets, op to 5mm radius fillet, no problem, but i want a 30mm radius fillet, because that's the radius of...