Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Create tet10 elements

Status
Not open for further replies.
paulis

paulis

Chemical
May 31, 2008
18
0
0
DE
Dear all, I would like to know if it is possible to create tet10 elements from triangular elements in ABAQUS 6.4.My problem is that I can change element by element but I can´t do it in a whole mesh. I am sending some pictures.

Thank you so much !
 
Status
Not open for further replies.

Similar threads

Parham.13.20
  • Locked
  • Question
How to create Line load
Replies
1
Views
20
FEA way
FEA way
Smadar11
  • Locked
  • Question
ABAQUS- stractural model- fine elements in crack area
Replies
3
Views
27
FEA way
FEA way
SinaPeugeot
  • Locked
  • Question
Bending-Only Shell Elements in Abaqus/Explicit
Replies
3
Views
22
SinaPeugeot
SinaPeugeot
hwa0725
  • Locked
  • Question
ABAQUS: How to create a Set for a WirePolyLine in Abaqus Scripting?
Replies
2
Views
31
hwa0725
hwa0725
Fblthp
  • Locked
  • Question
Abaqus How to show the coordinate system of beam elements in visualization window?
Replies
3
Views
43
FEA way
FEA way
Back
Top