Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Material Condition in Multiple Single Segment Position Tolerances

Status
Not open for further replies.
lmcchesney

lmcchesney

Mechanical
May 14, 2003
10
0
0
US
Does a material condition applied to a datum or tolerance zone in a single segment of a multiple single segment position tolerance have to be uniformly applied to all like datums or tolerances in every segment? I know it does in a composite position tolerance, but I'm not sure about multiple single segment.
 
Replies continue below

Recommended for you

Sort by date Sort by votes
Status
Not open for further replies.

Similar threads

AMontembeault
  • Question
Multiple Single Segment Positional Tol and Datums
Replies
7
Views
57
3DDave
3DDave
DimaM
  • Question
GD&T: How to inspect tertiary datum feature position tolerances?
Replies
7
Views
40
Burunduk
Burunduk
PtoMonty
  • Question
Position tolerance datums 3
2 3
Replies
42
Views
162
PtoMonty
PtoMonty
ryanwolff90
  • Locked
  • Question
Measuring flatness of primary datum in constrained condition? 1
Replies
18
Views
62
Burunduk
Burunduk
Wuzhee
  • Locked
  • Question
Multiple single segment with dynamic modifier
4 5 6
Replies
101
Views
102
Burunduk
Burunduk
Back
Top