Yesterday at 8:04 PM #1 FrancoisY Mechanical Nov 10, 2023 15 US Hi All, if a radius has a Max or Min radius call out, is it affected by the general tolerance table in the drawing? Thank you
Hi All, if a radius has a Max or Min radius call out, is it affected by the general tolerance table in the drawing? Thank you
Yesterday at 8:07 PM #2 jassco Mechanical Feb 22, 2011 484 US No. Your general tolerance table only applies to those dimensions that have not tolerance. Best regards, Alex Upvote 0 Downvote
No. Your general tolerance table only applies to those dimensions that have not tolerance. Best regards, Alex
Yesterday at 8:13 PM Thread starter #3 FrancoisY Mechanical Nov 10, 2023 15 US jassco said: No. Your general tolerance table only applies to those dimensions that have not tolerance. Best regards, Alex Click to expand... thank you! Upvote 0 Downvote
jassco said: No. Your general tolerance table only applies to those dimensions that have not tolerance. Best regards, Alex Click to expand... thank you!
Yesterday at 8:15 PM #4 looslib Mechanical Jul 9, 2001 4,205 US Be careful using a min radius. Basically anything larger than the min is allowed. There is no control on it unlike a max which sets a limit. Upvote 0 Downvote
Be careful using a min radius. Basically anything larger than the min is allowed. There is no control on it unlike a max which sets a limit.
Yesterday at 10:08 PM #5 y2k_o__o Petroleum Nov 20, 2022 6 CA Call out will overwrite anything in the general tolerance table Normally I don't control fillet radius unless it's a critical feature to avoid interference or stress concentration. Upvote 0 Downvote
Call out will overwrite anything in the general tolerance table Normally I don't control fillet radius unless it's a critical feature to avoid interference or stress concentration.
